Hopp til innhold

Norsk nettbutikk | Rask levering | Frakt i hele Norge

Nye produkter

Lykte kit komplet

3.713,-

Lyktesett  komplet til jeep wrangler yj.   Deler i sats er . Lykter høyre Venstre,  lykte holder, lykte feste justerings skruer  bezel lykt 
Front Runner knivsett

1.195,-

Flott knivsett fra Front Runner, består av 2 kniver i tre eske og overtrekk.     Esken kan brukes som skjærefjøl, det er også knivsliper på esken for å gjøre kniven skarpere ved behov. 
ISUZU D-MAX (2020-CURRENT) SLIMLINE II ROOF RACK ...

15.995,-

Gear up your Isuzu D-Max for any adventure with the Slimline II Roof Rack. The Slimline II’s lightweight, modular construction allows you to customize your setup with over 55 accessories. This particular Slimline II cargo roof rack kit features Low Profile Foot Rails to help minimize drag when carrying loads, which could make it more fuel-efficient.   This 1358mm/53.5" long, full-size, Slimline II cargo roof rack kit contains the Slimline II Tray, Wind Deflector and 2 Low Profile Foot Rails to mount the Slimline II Tray to your Isuzu D-Max. Easily installs using the existing factory mounting points. No drilling required. All Front Runner Rack Kits contain installation instructions as well as all the components needed to mount the Slimline II Tray to your vehicle. All Front Runner Racks are backed by a Limited Lifetime Warranty* Note: Some side mount accessories are not suited for low profile foot rails such as Hi-Lift Jack Bracket and Recovery Device & Gear Holding Side Brackets. * Note: A maximum driving speed of 130km/80mi per hour should be adhered to, when equipped with a Front Runner Roof Rack or Load Bar kit.
DRIVE SHAFT REPAIR KIT FRONT OR REAR HIGH ANGEL ...

3.795,-

Teraflex JK/JKU Rzeppa High-Angle Factory Replacement CV Joint Kit The TeraFlex JK/JKU Rzeppa High-Angle Factory Replacement CV Joint Kit replaces worn or damaged factory Rzeppa CV joint and driveshaft without resorting to an expensive aftermarket U-joint upgrade. The high-angle CV housing reduces boot failure common with 3” or more lift heights. The included low-friction grease is engineered specifically for the high RPM needs of the JK/JKU Rzeppa CV joint and features high-viscosity surface bonding characteristics necessary to properly adhere the grease to all moving surfaces.
Viser 21 til 30 (av 449 produkter)
  • klarna-dark.png