Bat Wing/Manta Wing Awning Brackets

1.995,-

Easily mount your Manta Wing or Bat Wing Awning to a Slimline II roof rack with these sturdy Front Runner brackets.   These corrosion resistant brackets secure a Manta Wing or Bat Wing Awning to the side profile of a Slimline II roof rack. No drilling required. The brackets simply bolt onto the t-slots in the side profile of your Slimline II Roof Rack. Pre-drilled mounting points designed specifically for Manta/Bat Wing Awnings allow installation in mere minutes. Made from steel and black powder coated with the same durable, weather resistant coating as the Slimline II Roof Rack.    

FRONT RUNNER SERIES PRO SKI, SNOWBOARD & FISHING ...

4.195,-

Securely store longer gear, such as fishing rods, snowboards and skis, on your Roof Rack with these alligator-grip style holders. Two (2) soft 30mm / 1.2” wide rubber grippers clamp your cargo tightly, without harming or scratching the surfaces of your valuable gear, in all weather conditions.

Ladder Frontrunner 260 cm

3.990,-

LAND ROVER DEFENDER 90/110 (1983-2016) LADDER

3.595,-

This ladder clamps onto the gutter and bolts to the vehicle body. The bottom rung mounts below the bumper using existing holes. The ladder conforms to the contours of the vehicle and is made with off-road tough black powder-coated high-strength steel for maximum durability and strength. Easy installation: The top part of the ladder clamps onto the gutter and bolts to the vehicle body (drilling required). The bottom ‘step’ mounts below the bumper using existing holes.

LED LIGHT BAR RACK MOUNT BRACKETS

795,-

Universal brackets that secure LED light bars either to the front or underneath a Front Runner rack. Supplied with two sets of brackets that secure an LED Light Bar to the Front Runner rack. Front Rack mounting brackets secure this light bar using the top and bottom T-slots of the front combined slat profile. Under Rack mounting brackets secure this light bar using the bottom T-slot of the front combined slat profile. Made of high strength steel and sealed with the same durable, weather resistant black powder coating as the Front Runner racks. Includes all installation hardware and fitting instructions.  

PICKUP ROLL TOP LEG MOUNT / MOUNTAIN TOP FRONT ...

1.399,-

This innovative mounting solution lets you mount a roof rack, or load bar system, over a pickup load bed when a Mountain Top Roll cover is already installed. Easily installed leg mounts attach to the top of the roller’s side extrusions using the supplied bolt plates. Legs are then secured to the mounts so you can effortlessly connect the rack or load bar system. Come in pairs. All installation hardware and simple step-by-step instructions are included.

PRO BED RECOVERY BRACKET

1.395,-

When stuck, you want quick access to your recovery boards. This is exactly what the Pro Bed Recovery Bracket offers, allowing you to conveniently attach your MAXTRAX, Tred Pro or Tred GT to the Pro Bed System. This Pro Bed Recovery Bracket bolts on the top and bottom side of the Pro Bed System. To attach your MAXTRAX, use the included Pro Bed Recovery Device Mounting Hardwareor MAXTRAX Mounting Pin Set * Sold Separately. The included Pro Bed Recovery Device Mounting Hardware can be used to mount your Tred Pro and Tred GT Recovery Boards. Mounting holes could be used mount other accessories to your Pro Bed System or Pro Bed Rack Kit. As a universal solution, the Pro Bed Universal Accessory Mount is available. For a complete water solution, Front Runner offers the Pro Bed Water Kit / 20L. Made of high strength steel and coated in the same durable, weather-resistant black powder coating as the Front Runner Rack.  

PRO BED TAILGATE NET

799,-

This Pro Bed Tailgate Net is a cargo saver that stops everything in your load bed from sliding out the back. It easily attaches to the integrated fixing points on the back of the Pro Bed System and Pro Bed Rack Rack Kits. It's a great way to ensure your gear stays where it should be. The Pro Bed Tailgate Net attaches to the integrated fixing points on the back of the Pro Bed System and Pro Bed Rack Kits. Designed to prevents items from sliding out the rear of the Load Bed. Adjustable to securely fit all Pro Bed System and Pro Bed Rack Kits. Made from high tensile polyester webbing with high quality buckles.

RACK PAD SET FRONT RUNNER

899,-

Transport your surfboard, SUP, skis, kayak, lumber, or whatever your adventurous heart desires, securely using these aerodynamic foam pads that perfectly fit the Front Runner rack slats or load bars. Don’t risk your expensive and fragile cargo on unpadded bars. Protect against dings and scratches so you can adventure worry free.   Quickly attach or remove the pads with the heavy-duty Velcro closure system. Pads secure around any standard Rack Slat or Load Bar.  For use at the front or rear on the Combined Slat of a Front Runner Rack, secure the pads using Black Tie Down Rings / Eye Nuts - SOLD SEPARATELY.  Use Stratchits or other tie down straps to quickly and easily tie-down your gear. Stratchits are SOLD SEPARATELY.  Firm foam for long-lasting reliability. Wide 24 inch / 61 cm pads for a range of uses and extra protection. Made with water resistant and durable outdoor grade fabrics. Set of 2 comes with nylon mesh bag for neat organization when not in use. Can adjust to fit many other factory racks and load bars. Note: This product is not compatible with Slimsport rack kit range.

STRATCHIT SHORTIES by Front Runner

429,-

Secure your cargo and gear with the more compact Stratchit Shorties. Stratchit Shorties are the ultimate efficient tie-downs with stretchy ratcheting performance in a lightweight, durable strap that is 507mm / 20" shorter than the regular Stratchit. Keep your rack clean and organized with the cinching hook and loop strap that neatly stows away excess strap length. Replace all of your cumbersome ratchet straps and stop wrestling with fixed length bungee cords. Stratchit Shorties have all the benefits of a compact ratchet strap and bungee cord combined. Cinch down loads simply and effectively so you don't have to worry about gear rattling loose on bumpy roads. Stratchit Shorties absorb tension like a stretchy ratchet strap. Stratchit Shorties are adjustable from 470mm / 18.5" in length to 1017mm / 40" in length. Quick and efficient. Simply secure the ends and hand tighten the strap. Fastens to, and around, just about anything. Perfect for Front Runner Racks and accessories, but work with all roof rack systems. Many uses! Secure: Wolf Pack Pro, Cub Pack and other cases (Pelican, Zargas, Alu-box, etc.) to any roof rack. Secure: Surfboards, SUP, bicycles, firewood, chairs, etc. For extra length Stratchits can be used. Keep your luggage secure inside the vehicle. Scrunch up your sleeping bags extra tight. Sold in pairs.   HOW TO USE: Hook to the Front Runner Roof Rack Tie Down Ring or loop around the slats or side profiles and fasten the Stratchit Shortie to itself. You can even remove the carabiner and loop the Stratchit Shortie through itself - to fasten around any roof rack rail, railing, pole, bumper, tire carrier.... etc. WARNINGS: Please read and follow all these warnings carefully -- failure to do so could result in cargo damage and could cause injury. Do not over tighten. Use only hand leverage. Never stand in the direct path of the Stratchit Shortie when tensioning to prevent the risk of injury should the strap become detached. Loads settle. Check Stratchit Shortie after first 10 miles of driving and each 50 miles thereafter. User to evaluate working load and requirements. DO NOT use to support human weight under any circumstance. Check the Stratchit Shortie regularly for signs of deterioration or damage. To ensure longevity, please remove the Stratchit Shorties from the sun and weather elements when not in use. Make sure that the points of attachment to the vehicle or trailer are of sufficient strength to withstand the maximum loading that will be produced during use. Take additional care if securing large objects that may be subject to aerodynamic lifting forces caused by bumps. Always use the appropriate number of straps and drive at reduced speeds to minimize the effects of these forces.

T-Slot Rubber Beading til Frontrunner Rack og ...

149,-

This rubber beading fits into your Front Runner Roof Rack t-slots to create a perfect rattle free and non-slip surface.  Sold in 1.5m/5' lengths. Need a little extra insulation between your rack and gear? The Front Runner T-Slot Rubber Beading slides easily into your Front Runner rack t-slots for extra grip and cushioning. It reduces rattles and is great for storage boxes, firewood, or any other item that you want to insulate from your rack. Comes in 1.5m (5') lengths.   On some vehicles with sun roofs, installing the t-slot beading on the front slats may help lessen wind noise.  

WOLF PACK PRO CARGO SYSTEM BRACKET

1.295,-

Mount or remove your Wolf Pack Pros in seconds from your Pro Bed System or Pro Bed Rack Kit with this specially-designed side-mounting system. These durable brackets will hold your storage bin securely in place through any terrain while giving you easy access to all your adventure gear when you need it. This Cargo System Bracket secures the Wolf Pack Pro to the side of the Pro Bed System and Pro Bed Rack Kit. The Wolf Pack Pro is side-mounted, allowing quick and easy access to all your adventure gear while keeping it safe from the elements. Made of high-strength steel and sealed with the same durable, weather-resistant powder coating as the Front Runner Racks. The top and bottom latches are lockable with a Rack Accessory Lock / Small, preventing unwanted access.  

BLACK TIE DOWN RINGS / EYE NUTS - BY FRONT RUNNER

175,-

These steel tie down rings can be used to attach just about anything to the top, sides or bottom of your Front Runner Rack. Galvanized steel, powder coated black. Sold in pairs.   The must have item to experience the full potential of the Front Runner Rack.  These easy to use tie down rings quickly and easily mount to a Front Runner Rack via the t-slots on the top, the bottom, and the side rails of the rack. No tools required. Just hand tighten. Slide these around anywhere on the rack for an endless supply of tie down points. Perfect for use with the Front Runner Stratchit or any style tie down strap. Mount unusual loads securely to a Rack for hassle free/rattle free travels where a specific mounting accessory is not available. Of all the accessories for the Front Runner Slimline II Roof Rack this is THE must have. Sold in pairs.

Stratchits - by Front Runner

449,-

Kraftige last stripp fra front runner . Justerbare fra 560mm til 1702 mm  Rustfrie karabinkroker i endene.     

EASY-OUT AWNING BRACKETS - BY FRONT RUNNER

800,-

These strong brackets are powder coated black with the same weather resistant finish as all Front Runner accessories .

QUICK RELEASE AWNING MOUNT KIT - BY FRONT RUNNER

1.995,-

Once these brackets are installed on a Front Runner Rack, no additional tools are needed to remove or refit the awning. Simply release the 2 latches and lift the awning away in seconds. No more wrenching in tight spaces during the “off-season” or time-consuming weekday removal of the awning. This strong and "rattle-free" mounting system is built off-road tough for use with Front Runner Racks. Works with all Front Runner Awnings and other popular awning brands like Eezi-Awn, Oz Tent, etc. 2 low profile base brackets are bolted to a Front Runner Rack while 2 self-aligning bushes are secured to the awnings mounting channel using the supplied fasteners. Safely secured in place using 2 latches with built-in safety catch. For added peace of mind, lock your latches in place using Rack Accessory Lock / Small. The brackets are small, unobtrusive and can be left on the roof rack when the awning is not mounted. No awning modification required. Removed awnings can be stored using the wall mount brackets supplied. Supplied with all required mounting hardware. Fitting instructions are included. Weight limit: 20kg (44.1lbs). Note: Not suitable for 270 degree awnings.  Monteringsanvisning

Viser 1 til 16 (av 29 produkter)